The Master 35® Anvil and Socket No Go Gauge was developed to help operators decide when to replace worn 1” anvils, sockets, extensions, etc.
Using worn sockets on a good anvil and good sockets on a worn anvil creates extra vibration, causes damage to the wrench, and increases the time it takes to loosen/tighten fasteners.
If the gauge can be fitted over the anvil or fully inside the socket square drive, they should be replaced.
- The gauge is supplied with a clip so it can be attached to a key ring or belt to reduce the chances of it being lost. It is made from high quality aluminum, hardened for long life.
- The Master 35 Anvil and Socket Gauge can be used on all types of 1” square drive impact wrenches and other brand impact sockets and accessories